Registration line enable, Registration line first-phone-number – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 457
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
24-13
Configuration - Voice Port Trunk Mode
registration line enable
Use the Voice Port Trunk registration line enable command to enable registration. To disable
registration, see no registration line enable command on page 24-10.
Syntax:
(config-vport-trk-{
n})# registration line value line-numbers
value enable
Example:
(config-vport-trk-1)# registration line 4 line-numbers 3 enable
Supported Platforms:
Adit 3500, MSR
registration line first-phone-number
Use the Voice Port Trunk registration line first-phone-number command to define the first
number in a block that will be registered.
Syntax:
(config-vport-trk-{
n})# registration line value line-numbers
value first-phone-number phone-number description description
Example:
(config-vport-trk-1)# registration line 1 line-numbers 3
first-phone-number 3032185555 description turin
Supported Platforms:
Adit 3500, MSR
Field
Definition
line value
Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value Define the number of lines in this block that are going to be registered.
Starting from the first-phone-number, increased by 1 each.
Field
Definition
line value
Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value Define the number of lines in this block that is going to be registered.
Starting from the first-phone-number, increased by 1 each.
phone-number
Enter the first number in a block that will be registered.
description
Enter a description with a maximum of 20 characters.