Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 362)

15-20 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - L2TPC Mode
no ppp username
Use the L2TPC no ppp username command remove the PPP username. To set a PPP user, see ppp
username command on page 15-23.
Syntax:
(config-l2tpc-{n})# no ppp username username
Example:
(config-l2tpc-1)# no ppp username test-user-name
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no schedule-availability
Use the L2TPC no schedule-availability command to disable a schedule rule . To add a rule, see
schedule-availability command on page 15-23.
Syntax:
(config-l2tpc-{n})# no schedule-availability
Example:
(config-l2tpc-1)# no schedule-availability
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no shutdown
Use the L2TPC no shutdown command to set the interface up (In-Service) . To set the interface
down (Out-of-Service), see shutdown command on page 15-24.
Syntax:
(config-l2tpc-{n})# no shutdown
Example:
(config-l2tpc-1)# no shutdown
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no sip-alg
Use the L2TPC no sip-alg command to disable SIP ALG on this interface. To enable SIP ALG, see
sip-alg command on page 15-24.
Syntax:
(config-l2tpc-{n})# no sip-alg
Example:
(config-l2tpc-1)# no sip-alg
Supported Platforms: Adit 3104, Adit 3500, MSR