Interlogix DVR 42 User Manual - Manual (Page 136)

134 TruVision DVR 42 User Manual
Restoring default settings
To restore the default factory settings of the DVR:
1. From the menu toolbar, click System Settings > Configuration .
2. Click the Default button. Enter the Admin password, click OK , and then click
Yes to confirm that you want to restore all parameters to default.
– Or –
Click the Restore button. Enter the Admin password, click OK, and then click
Yes to confirm that you want to restore all parameters except network settings
to default.
Note: Network information, such as IP address, subnet mask, gateway, MTU,
NIC working mode, server port, and default route, is not restored to factory
default settings if Restore is selected.
3. The system immediately starts to restore the settings.
Viewing system information
To view system information:
1. Click the System Settings icon in the menu toolbar and select System
Information .
2. To view device information, click the Device Info tab.