Interlogix DVR 42 User Manual - Manual (Page 120)

118 TruVision DVR 42 User Manual
Configuring the server and HTTP ports
You can change the server and HTTP ports from the default settings in the
Network Settings window. The default server port is 8000 while that of the default
HTTP port is 80.
Note: The server port has a port range of 2000 to 65535 and is used for remote
client software access. The HTTP port is used for remote internet browser
access.
To change the default ports:
1. From the menu toolbar, click Network Settings > More Settings .
2. Enter the new Server Port and HTTP Port values.
Configuring the RTSP service port
The RTSP (Real Time Streaming Protocol) is a network control protocol
designed for use in entertainment and communications systems to control
streaming media servers.
To configure RTSP service port:
1. From the menu toolbar, click Network Settings > More Settings .
2. Enter the RTSP port value. The default value 554.
3. Click Apply to save the settings.
Checking network status
You can easily check network traffic in order to obtain information about the DVR
such as its linking status, MTU, sending/receiving rate, MAC address, and NIC
type. You can save then this information to a storage device.
You can also check the network connection status by testing its delay and packet
loss.
To check network traffic:
1. From the menu toolbar, click System Settings > Net Detect > Traffic . The
Traffic window appears. The information displayed is refreshed once a
second.