Kenmore 385. 19000 - Manual (Page 62)

♦ Pull the button holder to the back, and place the
button in it. Push it together tightly on the
button,
@ Biinon lioldei
Sensor Buttonhoics, cont'd
♦ Pull the buttonhole lever dowtiward as far as it
will go.
CD Buttonhole lever
♦ Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the
needle at the start point.
Then lower the automatic buttonhole foot.
* Make sure there is no gap (?) between the slider
® and the spring holder ®.
If there is a gap (7), the length of the rows will
be different, as shown in (9).
( 4 ) Mark for placement of buttonhole
@ Starring point
® Slider ® Spring holder
(2) There shoud be no gap. ® Difference
* The buttonhole will be sewn automatically; the
front barrack and left row first, then the right
row and back barrack. The machine will stop
. automatically when the buttonhole is
completed.
♦ Depress the foot control until the machine stops
automatically.
4 Remove the fabric and place a pin just before the
barrack at each end to prevent cutting bartacks.
Cut the opening with the buttonhole opener.
4 When finished, push the buttonhole lever up as far
as it will go.
® Step 1
® Step 2
@ Step 3