Kenmore 385. 19000 - Manual (Page 102)

• If the Thread Breaks while Embroidering
Stop the machine by pressing the start/stop button.
Raise the presser foot.
Re-thread the machine.
Guide the thread tail around the thread holder from
the front side.
Press the |*i*| key.
Press the key until the hoop returns to the point
where the thread broke.
Lower the presser foot, and press the start/stop
button. (Do not cut off the extra thread yet.)
Upon completion of sewing, remove the embroidery
hoop and secure the loose ends of the thread rail
where the break occurred.
Beginning Key ;
If you run out of thread in the middle of sewing a word
(or some other pattern), and you want to start sewing
again from the beginning, press the beginning
key
Frame Return Key; |-^^|
This key is used to tesume sewing where the thread
has been broken. By pressing this key, you can move
the hoop to the point where the thread broke.
* The hoop is moved backward 10 stitches each time
the key is pressed.
Frame Advance Key ;
Pressing this key moves the hoop forward without
sewing. The key is used for correction when the hoop
is returned too far.
* The hoop is moved forward 10 stitches each time
the key is pressed.
Note: Before pressing keys,
make sure that the needle is at its
highest position.
86