Removing the bobbin – Kenmore 385. 19000 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Slide the hook cover plate release button to the
right, and remove the cover plate.
(T) Hook cover plate release button
(D Hook cover plate
Removing the Bobbin
• Inserting the Bobbin
♦
Place the bobbin in the bobbin holder with the
thread running off counterclockwise.
(T) End of thread
Guide the thread into the Notch ® on the front
side of the bobbin holder.
Draw the thread to the left, sliding it between the
tension spring blades.
(2)
Notch ®
4 Continue to draw the thread lightly until the thread
slips into Notch d).
Pull out about 15 cm
(6
") of thread.
(D Notch®
4 Attach the hook cover plate.
Check the threading by referring to the chart
shown on the hook cover plate.
(J) Threading chart