beautypg.com

Selection key, Changing needles, To attach and remove presser feet – Kenmore 385. 19000 User Manual

Page 26: To attach and remove presser foot, 3[s]sg, I o ol\ i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

selection key

Press [p7j key.

Select the language you need.

Press the |

| key to nicmotize the language

selected.

The screen will automatically be returned to the

main menu.

(D Language selection key

Note:

Regardless of which language is selected on the

machine, any message stored in the Memory Card

is shown on the visual touch screen in English only.

Changing Needles

Raise the needle by pressing the up/down needle

button and lower the presser foot.

Turn off the power switch.

Loosen the needle clamp screw by turning it

counterclockwise.

Remove the needle from the clamp.

Insert the new needle into the needle damp with

the flat side to the rear.

When inserting the needle into the clamp, push it

up as far as it will go. Tighten the clamp screw

firmly by turning it clockwise,

To check for a good needle, put the flat side of the

needle onto something flat (the needle plate, glass,

etc.).

The gap between the needle and the flat surface

should be consistent. Never use a bent or blunt

needle.

(T) Needle clamp screw

(D Pin

d) Needle clamp

To Attach and Remove Presser Feet

Press the red button on the back of the foot holder.

The presser foot will drop off.

Place the selected presser foot so the pin on the foot lies

just under the groove of the foot holder. Lower the

presser bar to lock the foot in place.

(T)Red button

@Groove

{

3

)Pin

+

♦1

flENU**

l i l D 1 O

abc

I O ol\

i

i

J

INGLISH

iFRARCAISl ESPANOL i

sen

[

mei

3[s]sg

IMH^

T3