Kenmore 385. 19000 - Manual (Page 24)

SECTION II GETTING READY TO SEW
Connecting Machine to Power Supply
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
• To sew using foot eontrol (Conventional sewing)
* First, turn off the power switch.
Second, insert the foot control plug (T) into the
machine.
Third, insert machine plug (2) into machine.
Fourth, insert power supply plug into eléctrica]
oudet.
(T) Foot control plug Machine plug
(3) Power supply plug (?) Power switch
(?) Power supply cord (§) Foot control
(2) Sticker (When embroidery sewing, the foot control can
not be used.)
• To sew using start/stop button (Embroidery sewing)
* First, mrn off the power switch (J).
Second, insert only the machine plug (^ into the
machine.
Third, insert power supply plug into electrical
outlet.
Turn on the power switch.
Note:
* The stan/smpbuuon cannot be used during
conventional sewing. It is used only for
embroidery sewing.
* The foot oonuol cannot be used in embroideiy mode.
* If you turn off the power switch, wait 5 seconds
before turning it on again.
* After turning on the power it is not abnormal
to hear a slight humming sound coming from
the internal motor.
For Your Safety
♦ While in operation, always keep your eye on the
sewing area, and do not touch any moving parts
such as the thread take-up lever, handwheel or
needle.
♦ Always turn off the power switch and unplug
from the power supply:
-When leaving the machine unattended.
-When attaching or removing parts.
—When cleaning the machine.
♦ Do not place anything on the foot control, except
in use.
Controlling Sewii^ Speed
Sewing speed can be varied by the foot oonuol.
The harder you press on the foot control, the foster the
machine runs.