AERCO ProtoNode Gateway Rev 3 (with external LEDs) - Manual (Page 28)

AERCO ProtoNode Gateway
User Manual
Page 28 of 126 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0080_0H
11/06/2014 Ph.: 800-526-0288 GF-129
CHAPTER 5:
Connect the ProtoNode’s Web GUI to Setup IP
Address for BACnet/IP*
*Available on ProtoNode Units with External LEDs, otherwise use the RUINET utility (section 6)
5.1 Connect the PC to the ProtoNode via the Ethernet Port
Figure 5-1: Ethernet port location of ProtoNode
1) Connect a standard CAT5 Ethernet cable (straight through or cross) between the PC
and ProtoNode.
2) The Default IP Address of the ProtoNode is 192.168.1.24, Subnet Mask is
255.255.255.0. If the PC and the ProtoNode are on different IP Networks, assign a static
IP Address to the PC on the 192.168.1.xxx network.
3) Go to: > >
4) Right-click on: Local Area Connection > Properties
5) Highlight: >
6) Select: Use the following IP address (as shown below)
7) Click: twice.
10/100 Base T
Ethernet
Connector
ProtoNode LER ProtoNode RER