Rockwell Automation Liqui-Flo AC GP Vector Drive Version 6.4 - Manual (Page 5)

Contents III
List of Figures
Figure 3.1 – Keypad/Display..................................................................................... 3-1
Figure 3.2 – Example of a Monitor Mode Display..................................................... 3-2
Figure 3.3 – Example of a Program Mode Display ................................................... 3-4
Figure 4.1 – Parameter Menu Structure ................................................................... 4-2
Figure 4.2 – Analog Output Selection and Scaling ................................................. 4-21
Figure 4.3 – Trim Reference Source Selection....................................................... 4-22
Figure 4.4 – Draw and Trim Gain ........................................................................... 4-23
Figure 4.5 – S-Curves............................................................................................. 4-25
Figure 4.6 – Typical Preset Operation .................................................................... 4-34
Figure 4.7 – Drive Start, Stop, and Running Status when Configured for
Edge Control vs. Level Control........................................................... 4-44
Figure 4.8 – Sample Alarm Circuit for LiquiFlo Drives Using the Level Sense
Enable Feature ................................................................................... 4-45
Figure 4.9 – Signal Selection for Network Output Registers .................................. 4-54
Figure 4.10 – Volts/Hz Ratio................................................................................... 4-55
Figure 4.11 – Torque Boost Voltage....................................................................... 4-56
Figure 4.12 – Avoidance Frequency Band ............................................................. 4-60
Figure 4.13 – Volts/Hertz Curve Selection.............................................................. 4-64
Figure 4.14 – Outer Control Loop Proportional Trim .............................................. 4-89