Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 97)

Publication 2711-UM014G-EN-P - September 2008 97
Configuring the Terminal Chapter 3
Reset Video
Resets the display to normal video (default settings).
On keypad terminals, the reset video [F15] key is also active on the
Configuration Mode menu. If the screen is non-viewable, press the
Left and Right arrow keys simultaneously. Then press [F15] to
reset the screen.
Exit
Returns to the Configuration Mode menu.
PanelView 1000 Grayscale Terminal Screen Setup
Video Mode
Toggles between normal video (darker text/graphics on a light
background) and reverse video (lighter text/graphics on a dark
background). The change takes effect immediately. Normal video is
recommended.
Screen Saver Mode
Sets the screen saver to Timed or Off. When Timed, the screen
intensity is reduced if user input or a controller screen change is not
received within the time specified in the Screen Saver Timeout box.
Screen Saver Timeout
Specifies when an inactive screen enters screen saver mode. The
timeout is adjusted in 5 minute increments with each key press, from
5…30 minutes.
IMPORTANT
Certain settings may make viewing the screen difficult. Do not
exit this screen until viewing adjustments are acceptable.
F16
EXIT
SCREEN SETUP
Screen
Saver
Video
Mode
Off Normal Reset
Video
SCREEN SAVER
10 min. 0
Timeout Intensity
F9 F10
F1 F2 F15