Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 110)

110 Publication 2711-UM014G-EN-P - September 2008
Chapter 4 Using a Memory Card
Load Application
on a Memory Card The steps below show how to load an application in the terminal onto
a memory card.
Follow these steps to transfer an application to a memory card.
1. Insert the memory card into the card slot of the terminal.
2. Open the Configuration Mode menu by simultaneously pressing
the Left and Right arrows (on keypad terminals), or the
Goto Config. Screen button (on touch screen terminals).
3. Select Memory Card and press the Enter
↵
key.
4. If necessary, press Erase/Format Card, [F4] key on keypad
terminals, to format or erase a 2711-NM11, 2711-NM12,
2711-NM13, 2711-NM14, or 2711-NM15 memory card.
WARNING
Explosion Hazard - Do not install or remove memory card unless
power has been switched off or the area is known to be
non-hazardous.
Function keys do not
appear on touch
screen terminals.
IMPORTANT
Do not perform this operation on a
2711-NM2xx ATA card (where xx is size in
megabytes). The card becomes inoperable.