Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 89)

Publication 2711-UM014G-EN-P - September 2008 89
Configuring the Terminal Chapter 3
Key Repeat Rate
Specifies the number of repeats that occur per second when a key is
pressed and held. Steps through key repeat rates: 0 (disabled),
200 ms (5 times/s), 250 ms (4 times/s), 330 ms (3 times/sec),
500 ms (2 times/s), 1000 ms (1 time/s).
Key Repeat Delay
Specifies how long a key must be pressed before it is repeated. Steps
through delay rates: 200 ms, 400 ms, 600 ms, 800 ms, 1000 ms,
1500 ms, 2000 ms, 2500 ms.
Exit
Returns to the Configuration Mode menu.
Viewing Terminal
Information Select Terminal Info from the Configuration Mode menu to display
information about your terminal. This information may be needed
when calling for technical support.
Boot
Displays the boot code revision.
Firmware
Displays the firmware revision.
Hardware
Displays the hardware configuration.
Keypad (CPS)
Touch Screen (TS)
Keypad and Touch Screen (TS CPS)
TERMINAL INFO
Boot: ############
Firmware: ############
Hardware:
#######################################
Filename:
Fontfile:
############
############
############
############
Bytes Used
Bytes Free F16
EXIT