Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 88)

88 Publication 2711-UM014G-EN-P - September 2008
Chapter 3 Configuring the Terminal
Restart Terminal
Resets the terminal.
Exit
Returns to the Configuration Mode menu.
Configure Presets Select Preset Operations from the Configuration Mode menu to set the
values of control objects after a reset or power cycle. You can set
presets to:
•
values provided by the PanelView application.
•
last values entered from terminal prior to a reset or power
down.
Power-up with Presets or Last States
Displays the current power-up selection. Use the up and down arrow
keys on keypad terminals (or the up and down keys on touch screen
terminals) to select an option. The selection takes effect the next time
the terminal is powered on.
•
Select Presets to load initial values of control objects (into
controller data tables) with values supplied by the application.
•
Select Last States to load initial values of control objects (into
controller data tables) with values entered at the terminal prior
to a terminal reset or power down.
Restart Unit and Load Values
Loads the values selected in the Power-up With list and resets the
terminal.
PRESET OPERATIONS
Last States
Presets
Key Repeat
Rate
1000 ms
F7
Key Repeat
Delay
200 ms
F15
Restart Unit
And
Load Values
F1
Power Up With:
F16
EXIT