Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 263)

Publication 2711-UM014G-EN-P - September 2008 263
Messages, Codes and Self-test Numbers Appendix B
These messages appear on the terminal screen as DC Error=xx. If you
get an alert number that is not listed here, contact technical support.
EtherNet/IP Codes
These messages appear on the terminal screen as DC Error=xx. If you
get an alert number that is not listed here, contact technical support.
ControlNet
Alert Codes Alert Type Indicates: Recommended Action
9000 Critical fault Interface startup failed. Contact technical support.
9003 Critical fault CIP S/N is not valid. Contact technical support.
9004 Critical fault Out of buffers. Contact technical support.
9010 Critical fault Invalid target node, target node
is the same as the PanelView, or
larger than the UMAX. Check node address of all devices on the network
including the PanelView terminal.
9012 Communication
Warning ControlNet object received a
reset request. Contact technical support.
9014 Critical fault A fatal CPU fault occurred. Contact technical support.
9015 Critical fault A ControlNet hardware fault
occurred. Contact technical support.
9016 Critical fault RAM verification failed at
startup. Contact technical support.
9017 Critical fault CRC verification failed at
startup. Contact technical support.
9018 Critical fault A critical internal error occurred. Contact technical support.
9019 Critical fault An internal fault occurred. Reset terminal, if problem occurs again, contact
technical support.
9020 Critical fault An internal fault occurred. Reset terminal. If problem occurs again, reload
application. If problem persists, contact technical
support.