Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 105)

105 Publication 2711-UM014G-EN-P - September 2008 105
Chapter
4
Using a Memory Card
Chapter Objectives This chapter describes:
•
supported memory cards.
•
using the memory card retainer.
•
loading application from a memory card.
•
loading application on a memory card.
•
storing font files on a memory card.
•
removing a memory card.
Supported Memory Cards Memory cards are available to transfer application files to/from a
PanelView terminal with a memory card slot. The PanelView 300
Micro terminal does not support a memory card.
PanelView terminals running firmware 3.0 (or later) and computers
with an ATA card drive support the following cards.
•
4M flash ATA card (Cat. No. 2711-NM24)
(1)
•
8M flash ATA card (Cat. No. 2711-NM28)
(1)
•
16M flash ATA card (Cat. No. 2711-NM216)
(1)
•
64M flash ATA card (Cat. No. 2711-NM232)
All PanelView terminals and computers with a DataBook TMB240 or
TMB250 card drive support these cards:
•
256K flash memory card (Cat. No. 2711-NM11)
(1)
•
1M flash memory card (Cat. No. 2711-NM12)
(1)
•
2M flash memory card (Cat. No. 2711-NM13)
(2)
•
4M flash memory card (Cat. No. 2711-NM14)
(2)
•
10M flash memory card (Cat. No. 2711-NM15)
(2)
(1) No longer available.
(2) Limited availability.