Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 253)

Publication 2711-UM014G-EN-P - September 2008 253
Messages, Codes and Self-test Numbers Appendix B
436 Logic Controller
has screen
control Reminder You tried to change the application
screen but it is configured for
controller only access. No action required, controller will
change screens as programmed.
634 Read Fail or
Write Fail Status ControlLogix Tag or address does not
exist or is the wrong data type.
Designated slot does not contain a
ControlLogix Processor.
Check tag address.
Check for data type mismatch.
Verify ControlLogix slot location.
1109 Font file
unavailable,
Font error = **** Minor Fault or
Terminal Fault You downloaded an application to the
PanelView without the appropriate
memory card (containing the font file)
inserted in the card slot of the
terminal. From the Memory Card screen, press
the Disconnect button to close the
files on the card. Remove the card
from the card slot. Locate the card
containing the font file or copy the
correct font file to a card. Insert the
correct memory card in the card slot
and enter Run mode.
1110 No valid
application Reminder You tried to run an application that
has not been downloaded to the
terminal. Download application to terminal.
1118 Access denied. Status Wrong password entered. Enter a valid password.
1119 Access denied. Status Password not recognized Enter a valid password.
1120 Security
tampering. Status PVA file was corrupted - attempt to
bypass security was detected New application file must be
downloaded to the terminal.
1121 No operator
selected. Status There is no currently selected
operator, but a password change has
been requested Select the operator requiring the new
password.
1122 Password change
is not allowed. Reminder Password is unchangeable Password cannot be changed at the
current level of security.
1123 Password change
is not allowed. Reminder Operator cannot change password Current operator does not have
access for password changes.
1124 New password
must be entered
before it can be
verified. Reminder New pass words must be entered
twice. Enter the new password again to
verify that it was entered correctly.
1125 New and verify
passwords differ. Status The same password was not entered
for verification. Enter the same password for New
and Verify.
1126 Please verify new
password. Reminder New pass words must be entered
twice. Enter the new password again.
1127 Password
changed Reminder Password change is effective. You must use new password for
security access.
2005 Application file:
Insufficient RAM Terminal Fault Application file may be too large. Try again. If possible, reduce the size
of the application.
2007 - 2010 Application file
contains errors Terminal Fault Application contains incompatible
data. Check application and try again.
Error Number Terminal
Messages Type Meaning Recommended Action