Rockwell Automation 2711 Standard PanelView Operator Terminal User Manual - Manual (Page 265)

Publication 2711-UM014G-EN-P - September 2008 265
Messages, Codes and Self-test Numbers Appendix B
16398 The Connection
Originator is
indicating it is in
Program Mode Comm Warning The logic controller is offline (in
Program Mode). The COMM Status
indicator on the Configuration Mode
menu is off. Place the logic controller in run mode
to resume communication.
16399 A fatal CPU fault
occurred Critical Fault A fatal CPU fault occurred. Contact technical support.
16401 The RAM check
failed Critical Fault RAM verification failed at startup. Contact technical support.
16402 The CRC check of
the firmware
failed Critical Fault CRC verification failed at startup. Contact technical support.
16403 OS startup failed Critical Fault Operating system failed to start. Contact technical support.
16404 PV Client Task
Fault Critical Fault Internal error has occurred. Contact technical support.
16405 Invalid preset
information
received from
motherboard. Critical Fault Internal error has occurred. Contact technical support.
16406, 16407 Connection with
Addr or scan rate
invalid or no
connection being
attempted. Critical Fault Internal error has occurred. Contact technical support.
16408 No buffers
available for read
operation Critical Fault Internal error has occurred. Contact technical support.
16409 DC couldn’t send
out the write
request in time. Critical Fault Too many write operations are
occurring. Contact technical support.
16410 Too many clients
attempted to
connect to server Critical Fault Internal error has occurred. Contact technical support.
16411 XS-WD creation
error Critical Fault Internal error has occurred. Contact technical support.
16412 XS-WD start
error Critical Fault Internal error has occurred. Contact technical support.
16413 ENet addr is not
valid Communication
Warning The EtherNet address for a device on
the EtherNet/IP network is invalid. Contact technical support.
16414 Duplicate IP
address detected Critical Fault The PanelView has the same IP
address as another device on the
EtherNet/IP network. Change the IP address of the
PanelView (on the Communication
Setup screen) so that is unique on the
network.
16415 Unknown error
detected Communication
Warning An operating system message has
occurred. Contact technical support.
16416 No network link Critical Fault Communication has not been
established with network. Check Ethernet cable.
Error Number Terminal
Messages Type Meaning Recommended Action