Rockwell Automation 25B PowerFlex 525 Embedded EtherNet/IP Adapter - Manual (Page 23)

Rockwell Automation Publication 520COM-UM001B-EN-E - March 2013 23
Chapter
3
Configuring the Adapter
This chapter provides instructions and information for setting the parameters to
configure the embedded EtherNet/IP adapter.
For a list of parameters, see Appendix B , Adapter Parameters . For definitions of
terms in this chapter, see the Glossary .
Configuration Tools The parameters can be configured using the drive keypad interface (see page 24 )
or a PowerFlex 4-class HIM (Human Interface Module, see page 25 ).
RSLogix 5000 (version 17 or greater), Logix Designer (version 21 or greater),
and Connected Components Workbench (version 3 or greater) can also be used
to access the parameters.
Topic Page
Configuration Tools 23
Using the Drive Keypad Interface to Access Parameters 24
Using the PowerFlex 4-Class HIM to Access Parameters 25
Using BOOTP 26
Setting the IP Address, Subnet Mask, and Gateway Address 29
Setting the Data Rate 30
Using Master-Slave Hierarchy 31
Setting a Fault Action 33
Resetting the Adapter 34
Viewing the Adapter Status Using Parameters 34