Rockwell Automation 25B PowerFlex 525 Embedded EtherNet/IP Adapter - Manual (Page 113)

Rockwell Automation Publication 520COM-UM001B-EN-E - March 2013 113
Troubleshooting Chapter 8
F687
F688
F689
F690
F691
F692 HW Addr 1
HW Addr 2
HW Addr 3
HW Addr 4
HW Addr 5
HW Addr 6 Decimal value of each byte in the adapter’s Ethernet hardware address.
F693
F694
F695
F696 EN IP Addr Act 1
EN IP Addr Act 2
EN IP Addr Act 3
EN IP Addr Act 4 Value of each byte in the adapter’s present IP address. A value of “0” appears if the
adapter does not currently have an IP address.
F697
F698
F699
F700 EN Subnet Act 1
EN Subnet Act 2
EN Subnet Act 3
EN Subnet Act 4 Value of each byte in the adapter’s present subnet mask. A value of “0” appears if the
adapter does not currently have a subnet mask.
F701
F702
F703
F704 EN Gateway Act 1
EN Gateway Act 2
EN Gateway Act 3
EN Gateway Act 4 Value of each byte in the adapter’s present gateway address. A value of “0” appears if the
adapter does not currently have a gateway address.
F705
F709
F713
F717
F721 Drv 0 Logic Cmd
Drv 1 Logic Cmd
Drv 2 Logic Cmd
Drv 3 Logic Cmd
Drv 4 Logic Cmd In Multi-drive mode, this is the logic command being transmitted to drive 0.
In Single-drive mode, this is the logic command being used by the drive (whether HS-
DSI, EtherNet/IP, or DSI) at the time. If comms control is NOT being used, and the drive is
in single-drive mode, then this parameter will show 0.
F706
F710
F714
F718
F722 Drv 0 Reference
Drv 1 Reference
Drv 2 Reference
Drv 3 Reference
Drv 4 Reference In Multi-drive mode, this is the reference being transmitted to drive 0.
In Single-drive mode, this is the reference being used by the drive (whether HS-DSI,
EtherNet/IP, or DSI) at the time. If comms control is NOT being used, and the drive is in
Single-drive mode, then this parameter will show 0.
F707
F711
F715
F719
F723 Drv 0 Logic Sts
Drv 1 Logic Sts
Drv 2 Logic Sts
Drv 3 Logic Sts
Drv 4 Logic Sts In Multi-drive mode, this is the logic status being received from drive 0.
In Single-drive mode, this is the logic status of the drive at the time.
Embedded EtherNet/IP Adapter Diagnostic Parameters
No. Name Description
255.255.255.255.255.255
[HW Addr 1]
[HW Addr 2]
[HW Addr 3]
[HW Addr 4]
[HW Addr 5]
[HW Addr 6]
255.255.255.255
[EN IP Addr Act 1]
[EN IP Addr Act 2]
[EN IP Addr Act 3]
[EN IP Addr Act 4]
255.255.255.255
[EN Subnet Act 1]
[EN Subnet Act 2]
[EN Subnet Act 3]
[EN Subnet Act 4]
255.255.255.255
[EN Gateway Act 1]
[EN Gateway Act 2]
[EN Gateway Act 3]
[EN Gateway Act 4]