Allied Telesis AT-S41 - Manual (Page 86)

AT-S41 User’s Guide
86
Configuring STP Port Settings
To configure the STP port parameters, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type S to select Spanning
Tree Configuration.
3. From the Spanning Tree Configuration Menu, type P to select
Spanning Tree Port Configuration.
The Spanning Tree Port Configuration Menu is displayed in Figure
23.
Figure 23 Spanning Tree Port Configuration Menu
4. Adjust the parameter settings as desired. To change a parameter,
type its corresponding bracketed letter and, when prompted, enter
the new information. The parameters are described below.
Set Port Pr[i]ority
Sets the parameter used as a tie breaker when two or more ports
are determined to have equal costs to the root bridge. The range
is 0-255. The default value for priority is 128.
Note
Port priority cannot be set on ports that are part of a trunk group.
AT-8350GB Local Management System
Spanning Tree Configuration->Spanning Tree Port Configuration Menu
Stack ID: 1
Port Trunk Link State Speed Priority Path Cost MAC Address
---- ------- ---- ---------- ----- -------- --------- ------------
1 --- Down Forwarding 10 128 10 00:01:12:34:45:1A
2 --- Down Forwarding 10 128 10 00:01:12:34:45:1B
3 --- Down Forwarding 10 128 10 00:01:12:34:45:1C
4 --- Down Forwarding 10 128 10 00:01:12:34:45:1D
5 --- Down Forwarding 10 128 10 00:01:12:34:45:1E
6 --- Down Forwarding 10 128 10 00:01:12:34:45:1F
7 --- Down Forwarding 10 128 10 00:01:12:34:45:20
8 --- Down Forwarding 10 128 10 00:01:12:34:45:21
9 --- Down Forwarding 10 128 10 00:01:12:34:45:22
10 --- Down Forwarding 10 128 10 00:01:12:34:45:23
11 --- Down Forwarding 10 128 10 00:01:12:34:45:24
12 --- Down Forwarding 10 128 10 00:01:12:34:45:25
-------------------------------- --------------------------
[N]ext Page [S]et Port Priority Set [T]runk Priority
[P]revious Page Set Path [C]ost Set T[r]unk Path Cost
Select Stack [I]D [Q]uit to previous menu
Command>
Enter the character in square brackets to select option