Allied Telesis AT-S41 - Manual (Page 195)

AT-S41 User’s Guide
195
Configuring STP Port Settings
To display and configure the STP settings, perform the following
procedure:
1. Click on the Basic Config menu tab and select Spanning Tree from the
sub-menu. Choose STP Port Config from the next sub-menu.
The Spanning Tree Port Configuration page will appear, as
displayed in Figure 76.
Figure 76 Spanning Tree Port Configuration
2. Select the Stack ID of the switch on which you want to configure STP
port settings and click the Apply button to the right of the Stack ID.
3. Adjust the parameter settings for a port as desired. The parameters
are described below.
The 8350GB Fast Ethernet switch has an All setting that allows a
global setting to be used for all ports on the switch.
Priority
This parameter is used as a tie breaker when two or more ports are
determined to have equal costs to the root bridge. The range is 0-
255. The default value for priority is 128.
Note
Port priority cannot be set on ports that are part of a trunk group.