Allied Telesis AT-S41 - Manual (Page 121)

AT-S41 User’s Guide
121
6. Enter a traffic class.
The following prompt is displayed, where X equals the traffic class
specified in the last step.
Enter queue for traffic class X>
Queue is in range of 0 to 1
7. Enter a priority queue (0 - 1).
Note
The default setting for traffic classes 0 - 3 is the low priority queue.
The default setting for traffic classes 4 - 7 is the high priority queue.
All tagged frames will be directed to either the low or high priority
queue as specified.
Note
The tagged information in a frame is not changed as the frame
traverses the switch. A tagged frame leaves a switch with the same
priority level that it had when it entered the switch.
The priority level of tagged frames is determined by the priority
level specified in the frame itself.
8. Repeat this procedure to configure priority levels for other traffic
classes on the switch.