Allied Telesis AT-S41 - Manual (Page 164)

AT-S41 User’s Guide
164
Configuring SNMP Community Strings and Trap IP Addresses
To configure the SNMP community strings for the switch and to assign
up to four IP addresses of management stations to receive traps from
the switch, perform the following procedure:
1. Click on the Basic Config menu tab and select SNMP Config from the
sub-menu.
The SNMP Configuration page is displayed, as shown in Figure 59.
Figure 59 SNMP Configuration Page
2. Adjust the parameters as desired. To change a value, change the
information in the data entry fields or pull-down menus and click the
Apply button. The parameters are described below.
SNMP Read Community
This parameter specifies the SNMP read community name. The
maximum length for a read community name is 20 characters.
This parameter is public.