Allied Telesis AT-S41 - Manual (Page 165)

AT-S41 User’s Guide
165
SNMP Write Community
This command specifies the SNMP write community name. The
maximum length for a read community name is 20 characters.
This parameter is private.
Enable/Disable Authentication Trap
This command specifies a community’s trap authentication.
SNMP Trap Receivers: IP Address
Allows you to add up to four SNMP trap receivers.
SNMP Trap Receivers: Community
Allows you to add a community name for each SNMP trap
receiver.
Enable/Disable/Delete SNMP Trap Receiver
Allows you to specify the status of a trap receiver or to delete the
trap receiver.
Changes to the SNMP parameters are immediately activated on
the switch.
3. To restore the switch’s default SNMP settings, click the Restore
button.