Allied Telesis AT-S41 - Manual (Page 35)

AT-S41 User’s Guide
35
Configuring an IP Address
The procedure in this section explains how to manually assign an IP
address, subnet mask, and gateway address to an AT-8350GB stack from
a local or Telnet management session. If the stack is to obtain its IP
configuration from a DHCP server on your network, go to the procedure
Activating DHCP on page 42.
To manually set a stack’s IP address, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type I to select System IP
Configuration.
The System IP Configuration Menu is displayed in Figure 4.
Figure 4 System IP Configuration Menu
3. Change the parameters as desired. To change a parameter, type the
bracketed letter in the corresponding command and, when
prompted, enter the new information.
The commands for changing the parameters in the System IP
Configuration Menu are described below:
[I]P Address
This command specifies the IP address of the stack. You must
specify an IP address if you intend to remotely manage the switch
using a Web browser, a Telnet utility, or an SNMP management
program.
AT-8350GB Local Management System
Basic Switch Configuration -> System IP
Configuration Menu
MAC Address: 00:40:33:FF:01:3B
IP Address: 149.35.19.3
Subnet Mask: 255.255.0.0
Default Gateway: 0.0.0.0
DHCP Mode: Disabled
---------------------- ----------
----------------
Set [I]P Address
Set Subnet [M]ask
Set Default [G]ateway