Allied Telesis AT-S41 - Manual (Page 166)

AT-S41 User’s Guide
166
Resetting the Management Software Default Values
The procedure in this section returns all management parameters to
their default values. This procedure also deletes any VLANs that you
have created on the switch.
Note
The management software default values can be found in
Appendix A, AT-S41 Default Settings on page 232.
To return the management software to its default settings, perform the
following procedure:
1. Click on the Tools menu tab and select System Reboot from the sub-
menu.
The System Reboot Configuration page will be displayed, as
shown in Figure 60.
Figure 60 System Reboot Configuration
2. Select a Reboot Status of Start from the pull-down menu. The Reboot
Status default setting is Stop.
3. Select a Reboot type of Reset to Factory Default from the pull-down
menu.
4. Click the Apply button. The switch resets and reboots immediately.