Allied Telesis AT-S41 - Manual (Page 46)

AT-S41 User’s Guide
46
Activating the Management Software’s Default Values
The procedure in this section returns all management parameters in a
stack to their default values. This procedure also deletes any VLANs that
you have created in the stack.
Note
The management software default values can be found in
Appendix A, AT-S41 Default Settings on page 232.
To return the management software to its default settings, perform the
following procedure:
1. From the Main Menu, type T to select Switch Tools.
2. From the Switch Tools Configuration Menu, type R to select System
Reboot.
The System Reboot Menu is displayed in Figure 9.
Figure 9 System Reboot Menu
3. From the System Reboot Menu, type O to select Set Reboot Option.
The following prompt is displayed:
Select reboot option (F/I/N)
4. If you want all parameter settings including the IP address and subnet
mask return to the default settings, type F. If you want all parameter
settings excluding the IP address and subnet mask return to the
default settings, type I.
5. Type R to Start Reboot Process.
The following prompt is displayed:
AT-8350GB Local Management System
Main Menu -> System Reboot Menu
Reboot Status: Stop
Reboot Type: Normal
------------------------ ---------------------
Set Reboot [O]ption
Start [R]eboot Process
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option