Allied Telesis AT-S41 - Manual (Page 120)

AT-S41 User’s Guide
120
Configuring QoS
To configure QoS on the switch, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
2. From the Advanced Switch Configuration Menu, type S to select
Quality of Service Configuration.
The Quality of Service Configuration Menu is displayed in Figure
31.
Figure 31 Quality of Service Configuration Menu
3. From the Quality of Service Configuration Menu, type S to select Set
Status.
The following prompt is displayed.
Enable or Disable QoS (E/D) >
E for Enable; D for Disable
4. Type E to enable QoS or D to disable QoS. The default setting is
Disabled.
5. If you activated QoS and want to change the queue assignments, type
P to select Set Priority Queue.
The following prompt is displayed.
Enter Traffic Class
Traffic class is in range of 0 to 7
AT-8350GB Local Management System
Advanced Switch Configuration -> Quality of Service Configuration
Menu
QoS Status : Disabled
Traffic Class Queue
------------- -------------
0 1
1 1
2 1
3 1
4 0
5 0
6 0 0 : Highest
7 0 1 : Lowest
---------------------------- ----------------------------
-
Set [S]tatus
Set [P]riority Queue
[Q]uit to previous menu
Command> _
Enter the character in square brackets to select option