Allied Telesis AT-S41 - Manual (Page 57)

AT-S41 User’s Guide
57
Configuring Gigabit Port Type
Ports 49 and 50 can operate as either GBIC ports or as 10/100/1000 Mbps
twisted pair ports. The default port type setting is twisted pair. In order
to change the use of these ports from one type to another, the port type
must be changed in the AT-S41 management software.
To configure the gigabit port type, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type G for Select Giga
Port Type.
The Select Giga Port Type Menu is displayed in Figure 15.
Figure 15 Select Giga Port Type Menu
3. Type I to choose Select Stack ID and enter the ID number of the switch
in the stack whose gigabit port type you want to change. (You can
skip this step if you are changing the gigabit port type on the master
switch, which is selected by default.)
4. From the Select Giga Port Type Menu, type S to select Set giga port
type.
The following prompt is displayed:
Enter giga port number >
Port number is in range of 49 to 50
5. Enter the number of the gigabit port whose type you want to change.
The following prompt is displayed:
Set giga port type for port 49 (G/T)>
G for GBIC; T for TP
AT-8350GB Local Management System
Basic Switch Configuration -> Select Giga Port Type Menu
Stack ID: 1
Giga Port NO. Port Type
------------- ---------------
49 TP
50 TP
-------------------------------- ------
[S]et giga port type
Select Stack [I]D
[Q]uit to previous menu
Command>
Enter the character in square brackets to select option