Allied Telesis AT-S41 - Manual (Page 44)

AT-S41 User’s Guide
44
Enable/Disable SNMP [T]rap Receiver
This command specifies the status of a trap receiver. This
parameter can be set to E for enable or D to disable.
[A]dd SNMP Trap Receiver
This command allows you to add an SNMP trap receiver. The
range is set of 1 to 4.
[D]elete SNMP Trap Receiver
This command deletes a specified SNMP trap receiver.
[E]nable/Disable Authentication Trap
This command specifies a community’s trap authentication. This
parameter can be set to E for enable or D to disable.
Changes to the SNMP parameters are immediately activated on
the stack.