Allied Telesis AT-S41 - Manual (Page 37)

AT-S41 User’s Guide
37
Configuring System Administration Information
The procedure in this section explains how to assign a name to the stack,
along with other optional information, such as the name of the
administrator responsible for maintaining the stack and the location of
the stack.
To set the administration information, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, select A for System
Administration Configuration.
The System Admin. Configuration Menu is displayed in Figure 4.
Figure 5 System Admin. Configuration Menu
3. Change the parameters as desired. To change a parameter, type the
bracketed letter in the corresponding command and, when
prompted, enter the new information.
The commands for changing the parameters in the System
Administration Configuration Menu are described below:
Set System [N]ame
This command specifies a name for the stack (for example, Sales).
This parameter is optional and may contain up to 50 characters.
Note
It is advised that you assign each stack a name. The names can help
you identify the various stacks when you manage them and can
help you avoid performing configuration procedures on the wrong
stack.
AT-8350GB Local Management System
Basic Switch Configuration -> System Admin.
Configuration Menu
Description: AT-8350GB
Object ID: 1.3.6.1.4.1.207.1.4.52
Name:
Location:
Contact:
--------------------------- ------
---------------
Set System [N]ame
Set System [L]ocation
Set System [C]ontact Information