Allied Telesis AT-S41 User Manual
Page 43
AT-S41 User’s Guide
43
Configuring SNMP Community Strings and Trap IP Addresses
To configure the SNMP community strings for the stack and to assign up
to four IP addresses of management stations to receive traps from the
stack, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
2. From the Basic Switch Configuration Menu, type N to select SNMP
Configuration.
The SNMP Configuration Menu is displayed in Figure 7.
Figure 7 SNMP Configuration Menu
3. Adjust the parameters as desired. To change a parameter, type the
bracketed letter in the corresponding command and, when
prompted, enter the new information.
The commands are described below:
Set SNMP [R]ead Community
This command specifies the SNMP community name. The
maximum length for a read community name is 20 characters.
Set SNMP [W]rite Community
This command specifies the SNMP write community. The
parameter can be set to private or public.
[M]odify SNMP Trap Receiver
This command specifies trap receiver information. This allows you
to modify the IP address and community name of a trap receiver.
AT-8350GB Local Management System
Basic Switch Configuration -> SNMP Configuration Menu
SNMP Read Community: public
SNMP Write Community: private
Trap Authentication: Enabled
SNMP Trap Receivers:
No. Status IP Address Community
---- -------- ---------------- -------------------
1 Deleted
2 Deleted
3 Deleted
4 Deleted
--------------------------------
Set SNMP [R]ead Community [A]dd SNMP Trap Receiver
Set SNMP [W]rite Community [D]elete SNMP Trap Receiver
[M]odify SNMP Trap Receiver [E]nable/Disable Authentication Trap
Enable/Disable SNMP [T]rap Receiver [Q]uit to previous menu
Command> _