Horner APG SmartStack I/O HE800DNS600/HEDNS600 - Manual (Page 64)

MAN0577-03-en
Page 64 of 98 EO 09-0009
DeviceNet Modules
HE800DNM650 & HE800DNS600
The scope can be given with the Device Selection menu point. The following can be chosen:
• All
• From Station address to Station address
• Selection of a device by means of its description
If no option is selected and the OK button is pressed nothing will be printed out. It is like clicking the
Cancel button.
7.3. Export Functions
7.3.1. DBM Export
Select the File > Export > DBM menu in order to save the previously saved project file (*.DN
Microsoft Access Format) in a DBM file (Hilscher binary format). This DBM file can be retrieved in the
DOS Compro program. The configuration is stored in the Project directory in the path of the HSyCon
Installation with extention *.DBM.
7.3.2. CSV Export
With the menu File > Export > CSV the configuration data of the connected Slaves can be exported
into a table.
Requirement is that the configuration was saved before the export is executed. The exported file has
the ending .csv (comma separated value) and is placed in the same directory as the configuration, but
with the ending *.csv.
The CSV file can be read with a table program like for example Excel.
The CSV Export saves only the text and the values of the configured Slaves. The meaning of the
individual values can be shown in the table.
Here is the description of the text and values:
Value Meaning
Stationaddress The Stationaddress is the clear device address of the Slave on the
bus.
RecordType The RecordType defines the arrangement of the structure and is
always defaultly 2.
IdentNumber This number is the clear device number of the Slave (if available).
VendorNumber The VendorNumber is the clear number of the vendor (if available).
VendorName
Here the name of the vendor is shown.
Device Name of the device.
Description This is the description of the device, which is set by the user.
MasterAddress This is the number of the Master Address, where the devices are
connected to (if available).
Settings The Settings of the I/O Data is shown here.
Reserved reserved
ModulCount The ModulCount gives the number of the actual modules. Depending
on this there are the DataType, DataSize, DataPosition and the
Address from 0 to 59.
DataType_0 The DataType, which is used in the configuration. The code for this
can be found in section 7.3.2.1. DataType Code.
DataSize_0 Number of bytes, which were used by the module.
DataPosition_0 The byte DataPosition, which is used in the configuration. The code for
this can be found in section 7.3.2.2. DataPosition Code.
Address_0 Offset Address in the Dual-port memory
Table 20: CSV Export - Meaning of the values