Red Lion IndustrialPr 6000 Router - Manual (Page 91)

Software User Guide 91
Services Tab
• To delete an address, select it in the table and click on the Delete button. To edit an existing rule, select it in the
table and click on the Edit button.
• Click on the “Save” button for changes to be saved without activating the interface until you reboot the unit, the
“Apply” button will save your settings and apply them immediately. To revert to the previous defaults, click on the
“Revert” button.
3.5.2 DHCP Relay
This feature will enable a DHCP Relay service, which will connect a local interface with a remote DHCP Server. DHCP Relay
should not be enabled for any interface(s) which have been configured to act as a DHCP server.
• Click on DHCP Relay and the following dialog window will appear:
Enable DHCP Relay: Select YES to enable the DHCP Relay, or NO to disable it. The service will start once the Apply but‐
ton is clicked. If the Save button is clicked, the service will not be started until the device is rebooted and then only if
the Start at boot time option has also been set to YES.
Start at boot time: Select YES to enable the DHCP Relay at boot time, or NO for manual control. If the DHCP Relay ser‐
vice is required to be operational at all times, then set to YES. If another process, such as VRRP, is going to dynamically
enable/disable DHCP Relay service as needed, then set to NO.