Red Lion IndustrialPr 6000 Router - Manual (Page 89)

Software User Guide 89
Services Tab
Global Settings:
Enter Domain Name: Enter the domain name that will be passed to DHCP Clients.
Use Sixnet Standard DNS Settings:
• Choosing “Yes” will automatically use the DNS Servers obtained by this unit’s internet connection and/or entries speci‐
fied in Networking

DNS Settings. This is the preferred method of operation.
• Choosing “No” will allow you to issue custom DNS servers to connected DHCP Clients. This will not affect any DNS Servers
used by this unit for local domain resolution.
Default Lease Time (seconds): Specify the amount of time, in seconds, that the DHCP Server will allow clients to main‐
tain their leases. Default value is “14400” (4 hours).
Maximum Lease Time (seconds): Specify the amount of time, in seconds, that the DHCP Server will allow clients to
maintain their leases. Default “86400”(24 hours).
Minimum Lease Time (seconds): Specify the amount of time, in seconds, that the DHCP Server will allow clients to
maintain their leases. Default “3600”(1 hour).
eth0:
Enable DHCP: Specify whether you want to enable a DHCP Server for the interface. Note: If the interface is not
enabled, or has been set to obtain its addressing parameters via DHCP, this option will be forced to “No”, and disabled
until the interface is both enabled and set to use a static IP address.
Enable Default Gateway: Provide Default Gateway IP Address to DHCP Client. Select No if you wish to only gain access
to this device’s web interface and have another connection from your PC out to the internet. Select Yes if you wish to
gain access to the internet through this device.
Starting Address (Required): Enter the Starting IP Address of a range you want the DHCP Serer to provide for clients.
Recommended Setting: An address valid for the subnet for which the interface is configured. Care should be used to endure
that there is no conflict with any pre‐existing devices on that subnet which may have been already configured to use statically
assigned IP addresses.
Ending Address (Required): Enter the Ending IP Address of a range you want the DHCP Server to provide for clients.
Recommended Setting: An address valid for the subnet for which the interface is configured, beyond that chosen for the
starting value of the range. Care should be used to ensure that there is no conflict with any pre‐existing devices on that sub‐
net which may have been already configured to use statically assigned IP addresses.
usb0:
Enable DHCP: Specify whether you want to enable a DHCP Server for the interface. Note: If the interface is not
enabled, or has been set to obtain its addressing parameters via DHCP, this option will be forced to “NO”, and disabled
until the interface is both enabled and set to use a static IP Address.
Enable Default Gateway: Provide Default Gateway IP Address to DHCP Client. Select NO if you wish to only gain access
to this device’s web interface and have another connection from your PC out to the internet. Select YES if you wish to
gain access to the internet through this device.
Starting Address (Required Field): Enter the Starting IP Address of a range you want the DHCP Server to provide for
clients.
Recommended Setting: An address valid for the subnet for which the interface is configured. Care should be used to ensure
that there is no conflict with any pre‐existing devices on that subnet which may have been already configured to use statically
assigned IP addresses.
Ending Address (Required Field): Enter the Ending IP Address of a range you want the DHCP Server to provide for cli‐
ents.