1 eth0 (wan) and eth1(lan) - (internet interfaces) – Red Lion IndustrialPr 6000 Router User Manual
Page 50
Software User Guide
50
Network Tab
3.4.2.1
eth0 (WAN) and eth1(LAN) ‐ (Internet Interfaces)
The configuration of the Ethernet ports is the same for eth0 and eth1, therefore this section will only reference the config‐
uration of “WAN”/’eth0’. Please refer to this section when configuring “LAN”/’eth1’.
•
Click on the “eth0 (WAN)” menu item and the following window will appear:
Enable eth0 Interface: This field determines if the specified Ethernet port is enabled, allowing the administrator to
disable the port if necessary.
Interface Speed/Duplex: Select the Speed and Duplex to be used for the physical interface. The recommended setting
for this field is Auto‐Detect.
•
Auto Detect: Use the ‘best negotiated’ speed and duplex. (default)
•
10Mbps/Half: Force the interface to 10 Mbps and half‐duplex.
•
100Mbps/Half: Force the interface to 100 Mbps and half‐duplex.
•
100Mbps/Full: Force the interface to 100 Mbps and full‐duplex.
Note: An incorrect ‘forced’ setting will result in communication failure for this interface.