Red Lion IndustrialPr 6000 Router User Manual
Page 73
Software User Guide
73
Network Tab
Ending Port (Required): Enter the ending TCP or UDP port number for this rule. Note: If adding only one port, please
omit this entry.
Interface: Select the interface on which this port will be opened. Incoming connections to this interface will be
allowed into the device. Note: For connections destined to a device beyond this unit, use Host Redirect, NAT or DMZ
rules instead.
Select Protocol: Choose the protocol for the type of data you want to allow.
Source Network via Whitelist: Select a whitelist name from the list of names available in the drop‐down list.
Whitelists may be viewed/defined in the via the Network/Firewall/ACL Rules screen.
•
Click on the Finish button. You will be returned to the Firewall Port Forwarding dialog window and the Service
Access (Allow) Rules table will now be populated with the recently entered data.
•
To delete an existing rule, select it in the table and click on the Delete button. To edit an existing rule, select it in
the table and click on the Edit button.
•
Click on the “Save” button for changes to be saved without activating the interface until you reboot the unit, the
“Apply” button will save your settings and apply them immediately. To revert to the previous defaults, click on the
“Revert” button.
Host Redirect (Port Forwarding) Rules: The Host Redirect Rules option is used to configure port forwarding rules that
permit ports on external, untrusted interfaces to be passed to ports on internal hosts on the same or different ports.
•
Click on the Add button on the following dialog window will appear:
Original Destination Port (Required): Enter the port that an external device will try to connect to. This is the port that
will be open on the specified interface.
Select Interface: Select the interface on which to open the specified port. Incoming connections will be allowed.
New Destination IP Address (Required): Enter the IP Address that the incoming connection will be redirected to. This
can be an IP Address within or beyond this device.