HP StorageWorks IP Storage Router - Manual (Page 83)

Configuring the Storage Router
83 IP Storage Router SR2122-2 User Guide
Table 9: Collecting Configuration Information
Configuration
Item Description
Required or
Optional
Configuration
deployment
SCSI routing (storage router enables iSCSI hosts to access
Fibre Channel storage. Storage router manages access to
the Fibre Channel storage.)
Required
Management
interface IP address
and subnet mask
The IP address and subnet mask of the storage router
management interface.
Note: The management interface for each storage router
in a cluster must be on the same IP subnet.
Required
Static route for
management
interface
The destination IP address with subnet mask and then the
gateway IP address.
Required if the
storage router
is managed
from a subnet
other than the
one to which it
is physically
attached unless
the SR2122-2
will be
configured to
use RIP
listening (see
Chapter 6,
“Configuring
System
Parameters.” )
System name The name you want to use for the storage router. If you use
the services of a domain name server (DNS), the system
name is the same name you will enter and associate with
the management interface. Maximum length is
19 characters.
Required
GE Interface The Gigabit Ethernet interface used to communicate to the
IP network, either ge1 or ge2. The default is ge1.
Required for
SCSI routing
only
High availability
(HA) configuration
The storage router can run in either standalone or clustered
mode. The default is clustered. Standalone mode is
recommended if the storage router is not intended to
provide high availability along with other storage routers.
Required for
SCSI routing
only