HP Unified Extensible Firmware Interface User Manual
HP Software
This manual is related to the following products:
Table of contents
Document Outline
- HP UEFI System Utilities User Guide for HP ProLiant DL580 Gen8 Servers
- Contents
- 1 Introduction
- 2 Getting Started: Overview of the System Utilities
- 3 Accessing the System Configuration Menu
- Accessing the BIOS/Platform Configuration (RBSU) menu
- Accessing the System Options menu
- Accessing Boot Options
- Accessing Power Management
- Setting HP Power Profile
- Setting HP Power Regulator
- Configuring Advanced Power Management Options
- Setting Intel QPI Link Power Management
- Setting Intel QPI Link Frequency
- Setting QPI Bandwidth Optimization (RTID)
- Setting Minimum Processor Idle Power Core State
- Setting Minimum Processor Idle Power Package State
- Setting Energy/Performance Bias
- Setting Maximum Memory Bus Frequency
- Setting Channel Interleaving
- Setting Maximum PCI Express Speed
- Setting Dynamic Power Savings Mode Response
- Setting Collaborative Power Control
- Setting Redundant Power Supply Mode
- Setting ACPI SLIT Preferences
- Setting Embedded and Add-in Devices
- Setting the System Date and Time
- Accessing the Server Availability menu
- Accessing the Server Security menu
- Accessing the BIOS Serial Console and EMS Console
- Accessing the Server Asset Text menu
- Accessing Advanced Options
- Accessing Advanced System ROM Options
- Entering a Chassis Serial Number
- Entering a Product ID
- Setting ROM Selection
- Setting NMI Debug Button
- Setting Virtual Install Disk
- Setting PCI Bus Padding Options
- Setting Power-On Logo
- Enabling SR-IOV Support
- Setting Consistent Device Naming
- Setting PCI Express 64-Bit BAR Support
- Setting Processor X2Apic Support
- Setting ACPI RASF Table Support
- Setting ACPI Root Bridge PXM Preferences
- Configuring Extended Memory Test
- ACPI RTC Support
- Accessing Advanced Performance Tuning
- Setting HW Prefetcher
- Setting Adjacent Sector Prefetch
- Setting DCU Stream Prefetcher
- Setting DCU IP Prefetcher
- Setting Node Interleaving
- Setting 1333 MHz Support for 3DPC PC3-10600H HP SmartMemory
- Setting 1333 MHz Support for 3DPC PC3-12800R HP SmartMemory
- Enabling Intel NIC DMA Channels
- Setting Intel Performance Counter Monitor (PCM)
- Setting Video Options
- Setting Power Supply Requirements Override
- Setting Thermal Configuration
- Locking Asset Tag Protection
- Accessing Advanced System ROM Options
- Accessing System Default Options
- Accessing the BIOS/Platform Configuration (RBSU) menu
- 4 Accessing Smart Array Controllers
- 5 Using the iLO 4 Configuration Utility
- Accessing the iLO 4 Configuration Utility menu
- Configuring Network Options
- Configuring Advanced Network Options
- Managing iLO users by using the iLO 4 Configuration Utility
- Configuring access settings by using the iLO 4 Configuration Utility
- Viewing information about iLO
- Resetting iLO to the factory default settings by using the iLO 4 Configuration Utility
- Resetting iLO by using the iLO 4 Configuration Utility
- Accessing the iLO 4 Configuration Utility menu
- 6 Configuring a One-Time Boot Menu
- 7 Viewing System Information
- 8 Viewing Device Health Status
- 9 Selecting a Language
- 10 Exiting and Resuming Boot
- 11 Configuration flows (manual and scripted)
- 12 Support and other resources
- 13 Documentation feedback
- Glossary
- Index