HP Unified Extensible Firmware Interface - Manual (Page 18)

2. Select one of the following options:
•
“Selecting a UEFI PXE Boot Policy” (page 18)
•
“Setting Network Boot Retry Support” (page 19)
Figure 8 Network Boot Options screen
Selecting a UEFI PXE Boot Policy
You can select the UEFI PXE (Pre-Boot Execution Environment) network boot policy. If both IPv4 and
IPv6 are enabled, each network boot target appears twice in the UEFI boot order list (one for IPv4
and the other for IPv6). You can only configure this option when Boot Mode is set to UEFI. For
more information, see
“Selecting a Boot Mode” (page 41) .
To select a UEFI PXE boot order:
1.
From the System Utilities screen, select System Configuration
→BIOS/Platform Configuration
(RBSU)
→System Options→Network Boot Options→UEFI PXE Boot Policy and press Enter.
2. Select one of the following options:
•
IPv4 then IPv6
•
IPv4
•
IPv6
•
IPv6 then IPv4
•
Auto (default)
3. Press F10 to save your selection.
18 Accessing the System Configuration Menu