GW Instek LCR-8101 (Replaced by LCR-8101G) - Manual (Page 97)

GRAPH MODE
97
Backspace All clear
Clear
If a wrong unit is entered, the value is cancelled.
Unit Mismatched
If the entered Hi level is lower than the Lo level,
the two values are swapped.
Hi and Lo Swapped
Set Lo level 6. Press the Up/Down key to move the
cursor to Lo percentage and repeat
the same step.
Cs Lo: -19.500%
Range –1.0x10 12 (Tera) ~ 1.0x10 12 (Tera) %
Set Nominal 7. Press the Up/Down key to move the
cursor to Nominal.
Nominal: 1.0000mF
8. Use the numerical keys to enter the nominal
value on which the Hi and Lo percentages are
based.
Range According to each measurement item
(see page37).
1.2mΩ
m
Ω Enter
1.5kH
Enter H k
Backspace All clear
Clear
If a wrong unit is entered, the value is cancelled.
Unit Mismatched