GW Instek LCR-8101 (Replaced by LCR-8101G) - Manual (Page 113)

REMOTE CONTROL
113
*stb? Returns the current contents of the Status Byte
with the Master Summary bits as an integer in the
range 0 to 255. Bit 6 represents Master Summary
Status rather than Request Service.
*trg Triggers a direct measurement, but does not return
the results to the controller. This is the same as a
GET (Group Execute Trigger) command.
*wai Command has no effect as commands are
processed sequentially.
Measurement command
:dump-bmp Returns the current display as a windows
compatible bitmap.
:beep
:beep?
Sets or returns the buzzer condition.
Set parameter: off (disabled), pass (beeps when
passed), fail (beeps when failed)
Return parameter: 0 (off), 1 (pass), 2 (fail)
:loc-trig Turns On/Off local triggering in remote control
Parameter: on (local control), off (remote control)
:meas:equ-cct
:meas:equ-cct?
Selects or returns equivalent circuit.
Send parameter: ser, par
Return parameter: 0 (parallel), 1 (series)
:meas:freq
:meas:freq?
Sets or returns frequency of AC measurement in
Hz.
Parameter example: (1kHz) 1k, 1000 Hz, 1E3
:meas:func
Selects first or second AC measurement function.
Parameter: c, l, x, b, z, y, q, d, r, g
Example: :meas:func:c;d (C+D measurement)
:meas:func:major
? Returns the first AC function.
Parameter: 0 (C), 1 (L), 2 (X), 3 (B), 4 (Z), 5 (Y)