GW Instek LCR-8101 (Replaced by LCR-8101G) - Manual (Page 32)

LCR-8000G Series User Manual
32
Graph mode
Step Description Details
1. Connect fixture Connect the fixture to the DUT. Page24
2. Enter graph
mode Press the Menu key, then F4 (Graph). Page88
3. Select item Press F5 repeatedly to select the graph
item. Page89
4a. Set horizontal
scale (frequency) Press the Up/Down key to move the
cursor to Sweep. Press the Left/Right key
to select Frequency. Then move the cursor
to Start Frequency, set the value using the
numerical and unit keys. Repeat this for
Stop Frequency and Level (drive
Voltage). Page92
4b. Set horizontal
scale (voltage) Press the Up/Down key to move the
cursor to Sweep. Press the Left/Right key
to select Voltage. Then move the cursor to
Start Voltage, set the value using the
numerical and unit keys. Repeat this for
Stop Voltage and Freq (frequency). Page90
5. Select speed Press the Up/Down key to move the
cursor to Speed. Press the Left/Right key
to select the measurement speed. Page101
6. Select step size Press the Up/Down key to move the
cursor to Step size. Press the Left/Right
key to select the data step (all or
sampled). Page102
7. Select linear or
log scale Press F1 (Lin/Log) to select linear or
logarithmic horizontal scale. Page91
8a. Set vertical
scale (Absolute +
Auto fit) Press F2 (Abs/%) to select Abs, then press
F3 (Manual/Auto fit) to select Auto fit.
the LCR-8000G automatically configures
the vertical scale. Page98