GW Instek LCR-8101 (Replaced by LCR-8101G) - Manual (Page 36)

LCR-8000G Series User Manual
36
B
ASIC MEASUREMENT
Basic measurement measures DUT in numerical
style. Advanced measurements are available in
Pass/Fail test mode (page58), where measurement
results are compared with user-defined limits, and
in Graph mode (page87), where measurement
data is displayed in graphical representation.
Measurement
item
Measurement combination ........................................ 37
Series/Parallel circuit models ..................................... 38
Resistance (R) and Conductance (G = 1/R) .............. 40
Capacitance (C) .......................................................... 41
Inductance (L) ............................................................ 42
Reactance (X) and Susceptance (B = 1/X) ................. 43
Impedance (Z) and Admittance (Y = 1/Z) ................. 44
Quality factor (Q) and Dissipation factor (D) ........... 45
Angle (θ) ..................................................................... 46
Measurement
overview
Enter measurement mode .......................................... 47
Display overview ......................................................... 48
Show circuit model or scale (pass/fail) ..................... 49
Measurement
configuration
Select measurement item ........................................... 50
Set measurement range to Auto ................................ 51
Set measurement frequency ....................................... 52
Set measurement voltage ........................................... 54
Run measurement
Select Single measurement ........................................ 55
Select Repetitive measurement .................................. 56
Hide drive Voltage/Current ........................................ 57