beautypg.com

Command set, System command – GW Instek LCR-8101 (Replaced by LCR-8101G) User Manual

Page 112

background image

LCR-8000G Series User Manual

112

Command Set

System command

*cls

Clears the Event Status Register and associated
status data structure.

*ese

*ese?

Sets or returns the current contents of the Standard
Event Status Enable Register as an integer in the range
0 to 255.

*esr?

Returns the current contents of the Standard Event
Status Register as an integer in the range 0 to 255.
It also clears ESR.

*idn?

Returns the LCR identification: Manufacturer,
Model No, Serial No, Firmware version.
Example: GW INSTEK, 8101, 0, 2.04

*loc

Sets the instrument to local state.

*opc

Sets the OPC bit of the ESR register.

*opc?

Always returns 1 as instrument commands are
always processed sequentially.

*opt?

Returns the hardware options installed in the
instrument.
Example: 1MHz, GPIB, RS232, GRAPH MODE

*rst

Resets the LCR-8000G.

*sre

*sre?

Sets or returns the current contents of the Service
Request Enable Register as an integer in the range 0 to
63 and 128 to 255.

:stat:oper:con?

Reads Status Operation Condition register.

:stat:oper:enab

Sets Status Operation Enable register.

:stat:oper:even?

Reads Status Operation Event register.