GW Instek LCR-8101 (Replaced by LCR-8101G) - Manual (Page 37)

BASIC MEASUREMENT
37
Measurement Item Description
In general, two items, primary and secondary, are combined in a
single measurement. The following table shows the available
combinations. Overview of each measurement item is listed from
the next page.
Measurement combination
:Available, :Not available, :Combination doesn’t exist.
1st measurement 2nd measurement Circuit model Graph *Prog
Q D R
AC
G Angle Series Parallel
Capacitance (C)
Inductance (L)
Reactance (X)
Susceptance (B)
Impedance (Z)
Admittance (Y)
DC Resistance(R
DC
)
Quality factor (Q)
Dissipation factor (D)
AC Resistance (R
AC
)
Conductance (G)
Angle (θ)
*Prog: Multi-step program
 The graph measurement is described in the Graph Mode chapter,
page87.
 The multi-step program mode is described in the Pass/Fail test
chapter, page70.