GW Instek LCR-8101 (Replaced by LCR-8101G) - Manual (Page 71)

PASS-FAIL MODE
71
Parameters No. of step Maximum 30 for each program
No. of program Maximum 64
Drive Voltage
(1mV step) 10mV ~ 2V (DC or AC≤3 MHz)
10mV ~ 1V (AC>3 MHz)
Frequency 20Hz ~ 1MHz (LCR-8101G)
20Hz ~ 5MHz (LCR-8105G)
20Hz ~ 10MHz (LCR-8110G)
Bias Reserved item: internal use only
Speed Max, Fast, Med, Slow
Hi / Lo Limit Follows the measurement range
Delay 0 ~ 9999ms, 1ms step
Single trigger Program runs when the Trigger
key or F1 (Start) is pressed.
Automatic
trigger Program runs when the LCR-
8000G detects the DUT.