Spectra Precision Survey Pro v4.6 Recon and Nomad User Manual - Manual (Page 89)

Conventional Fieldwork
79
d. The rod man needs to move back by 0.2 feet to be
over the design point. Rather than take another
shot, we will instruct him to use a tape and place
a stake at that location. Tap the
. Store/Tape…
button to store the point.
e. Enter the following data in the Store Point (Tape
Offset) screen:
Point Name: 6
Description: Staked
Tape Out/Tape In (+/-): 0.2 and then tap . This
will result in coordinates for the stored point that
are 0.2 feet further from the total station than
the last shot to the prism.
Note: Negative Tape Out/Tape In values are toward the
total station and positive values are away from the total
station.
Point Staking Summary
1. Open a job that contains the design points that you want to stake.
2. Check the job settings.
3. Setup a backsight.
4. Stake the points from the Stake Points screen.